Home / Products / Battery charger accessories
Universal Remote Control
(for OC12-40, OC12-60, OC24-20 and OC24-30)
(art.no. 5095500)
The Universal Remote Control (URC) can be used to remotely readout all available parameters from your TBS charger, like charging current, output voltage, charge stage etc.. It is also possible to put the charger in standby mode or to wake it up again, besides being able to control the maximum charge current . All information is shown on a clear white backlit graphical display. This kit comes with mounting screws and a 3 meter interface cable (standard cat5 patch cable). The URC automatically recognizes to which type of equipment it is connected, so this same device can be connected to a Powersine or Powersine Combi product as well.
Download manual
Back to top
TBSlink communication kit
(for OC12-40, OC12-60, OC24-20 and OC24-30)
(art.no. 5092120)
The TBSlink communication kit contains a fully isolated TBSlink to USB interface box, a USB interface cable, a 3 meter interface cable (standard cat5 patch cable) and the "Dashboard" Windows software. The complete kit enables you to control, readout and configure the Omnicharge device from your Windows PC. Another possibility is to use the PC as a datalogger to record all measured parameters for further analysis.
Download installation guide TBSlink communication kit
Download Dashboard for Windows manual
Back to top
DC cable kit 2x1.5m/25mm˛
(for OC12-40, OC12-60, OC24-20 and OC24-30)
(art.no. xxxxxxx)
To connect the Omnicharge charger to your batteries, the DC cable kit contains two cables (red and black) of 1.5m length and 25mm˛ area. The cables are terminated with solid M8 ring terminals for an optimal connection. More lengths and sizes will be available in the near future.
Back to top
Alarm Output Expander kit
(for OC12-40, OC12-60, OC24-20 and OC24-30)
(art. no. 5055630)
The Alarm Output Expander kit, adds three additional alarm relays to your Omnicharge device. This kit can be used in case the application requires each alarm type to be assigned to a different alarm relay. Within the Dashboard setup for the Omnicharge device each alarm type can be assigned to '[1]' which is the internal relay, or to '[]2', '[]3' or '[]4' which are the external relays of this kit. Each relay can switch up to 60VDC with a maximum current of 1A @ 30VDC.
The Alarm output expander kit greatly increases the versatility of the Omnicharge battery charger in more complex systems.
Download installation guide alarm output expander kit
Back to top
